FORD CLEVELAND AC BUNDLE BLACK
 
Included in the Cleveland AC bundle is:
Low mount AC bracket
Mid mount alternator bracket
Serpentine pulley kit (pro series)
Serpentine belt - 6PK 1525
Eccentric idler Pulley 
Timing pointer
High voltage coil bracket (optional)
 
Low mount AC bracket
This bracket is designed to go with our mid mount alternator bracket and idler pulley as an add-on. This ac bracket will not work solo.
 
This bracket is made to fit most vehicles and sits very tight and close to the engine block. As each car and engine combination can change, we advise checking there is ample room for a low mount ac compressor prior to purchase.
 
This bracket has been designed to run the SANDEN SD-7B10 compressor. If using our pulleys and belt you will need to purchase the 6pk pulley version.
 
Mid Mount Alternator Bracket
 
⚠ Check the spec diagram in images for dimensions, bolt sizes & compatible alternators before ordering.
 
Designed by an engine builder, this bracket is extremely strong and holds the alternator close to the factory location.
 
The key elements that set this mid mount bracket apart:
Made from strong 6061 Aerospace alloy.
Space for idler pulley. This reduces the amount of belt shake/slap under high rpm loads, helping extend belt life.
Doesn't touch the cylinder heads.
Perfect fitment right out of the box - designed to directly replace factory alternator brackets and run the same backspacing so no need for extensive modifications if you are replacing your standard style alternator bracket.
 
NOTES:
Check product pictures for alternator spec. This bracket will work with Powermaster & Aeroflow alternators along with many other brands.
 
Works on standard blocks with standard 5/16 bolt hole sizes. If your timing cover bolt sizes vary from 5/16 (such as for iron eagle blocks) then you will need to bring them back to oem spec by using thread inserts. 
 
Designed to replace factory alternator bracket and will require 4 bolt raised face OEM spec harmonic balancer as seen on factory engines. If you have an aftermarket flat face balancer you will need to measure the balancer and purchase a raised hub for the balancer essentially bringing your aftermarket balancer back to factory measurement spec.
 
Recommended use is with mechanical water pump and idler pulley.
 
The image highlights the three mounting points (circled in red) on the engine block where our alternator brackets are designed to bolt up.
 
These brackets have been tested with aeroflow 140 amp ford alternators (Delco body) AF4273-1140
 
High Voltage Coil Bracket (optional)
One for all coil bracket that will hold all the major brands including ICE Ignition, MSD Ignition, and Aeroflow.
Crafted from robust 6061 aerospace aluminum.
Fits Cleveland cylinder heads perfectly.
Stainless steel hardware included.
Check 'Tech Specs' for compatibility.
 
 
All Unrivaled billet parts are considered aftermarket and suitable for racing/off road purpose, these are not OEM replacements fitment & vehicle safety is responsibility of vehicle owner. Unrivaled ensure that these parts are to the highest standards and fit the specified engines correctly. Vehicle fitment is responsibility of vehicle owner and pre purchase checking is advised before purchase of any billet aftermarket parts. There is no return on billet parts for change of mind or vehicle fitment issues.